Turn Limit Diagram

<body topmargin=0 leftmargin=0 marginheight=0 marginwidth=0> <table cellpadding=0 cellspacing=0 border=0><tr> <td valign="top" height=90 BGCOLOR="#006633" TEXT="#F7F7FF" bgproperties="fixed" background="079005a0ddvuru.png"> <div> <A HREF="http://www.vernco.com/index.htm" TARGET="_top" TITLE="http://www.vernco.com/index.htm"><U><B>home</B></U></A><B>     |     </B><FONT SIZE="5" COLOR="#FFCC66" FACE="Arial" ><B>Vernco.com</B></FONT></div> <div> <A HREF="http://www.vernco.com/id173.htm" TARGET="_top" TITLE="http://www.vernco.com/id173.htm"><U>Site Map</U></A>       back to<B>  </B><A HREF="id373.htm" TARGET="_top" TITLE="Kingpin Bearings"><U><B>Kingpin Bearings</B></U></A></div> <bR> <div> <B>Use your browser's Back button  for best results</B></div> <bR> <div> </div> </td> </tr><tr> <td valign="top" height=390 BGCOLOR="#FFFFFF" TEXT="#080000"> <bR> <div> <IMG SRC="907e12c0.jpg" border=0 width="737" height="556" ALIGN="BOTTOM" HSPACE="0" VSPACE="0"></div> <bR> <div> <B>The turn limit depends on the type of axle shafts installed.  C</B><B>lick </B><A HREF="id374_turn_limit_caution.htm" TARGET="_top" TITLE="Bendix Joints"><U><B>here</B></U></A><B> to learn more about a potential mistake in the service manual for these values</B><B>:</B></div> <bR> <div> <B>   Bendix  Joints = 23.0 degrees.  Use .3907 for the Sine of 23.0 degrees.</B></div> <bR> <div> <B>   Spicer   Joints = 27.5 degrees.  Use .4617 for the Sine of 27.5 degrees.</B></div> <bR> <div> <B>   Rzeppa Joints = 29.0 degrees.  Use .4848 for the Sine of 29.0 degrees.</B></div> <bR> <bR> <bR> <div> <B>As an example, my tire has a 27.5" diameter for the value (h).  The specified angle is 23 degrees maximum for a Bendix joint.  Multiply the Sine of 23 degrees (.3907) by (h) for a result of 10.75".  That is the desired difference between the measurements at the front and rear of the tire.</B></div> <bR> </td> </tr></table></body>